TECH TIP
Dodge Caravan fuel pump won’t run but fuse is good
Mar. 30 2021
Mar. 30 2021

Vehicle: 2013 Dodge Grand Caravan, V6-3.6L, Automatic Transmission/Transaxle

Mileage: 113,661

Problem: The vehicle was towed in for a “crank/no start” problem. According to the owner, it started as an intermittent “hard start/extended crank” issue, which eventually turned into the “crank/no start” problem, and at that point, the malfunction indicator light (MIL) came on.

Gran Caravan Fuel System

Case Details: When the technician checked for diagnostic trouble codes (DTCs), he found the following:

  • P0628 - Fuel Pump Control Circuit Low
  • P062A - Fuel Pump 'A' Control Circuit Range/Performance

His initial checks confirmed that there was no power at the fuel pump when cranking. Fuse M25 (20a) in the TIPM was good. At this point, he called ALLDATA Tech-Assist for some guidance.

The Tech-Assist consultant advised that, although the fuse was good, the technician should check for battery power at the fuse. If there was none, then apply power to the fuse to see if the fuel pump would run.

If it did, chances were good that the fuel pump relay had failed. NOTE: The relay is integral to the totally integrated power module (TIPM) and not serviceable separately.

To further diagnose the problem, the consultant suggested commanding the fuel pump ON with a scan tool. Also, verify that the PCM was sending power to the fuel pump relay at TIPM connector C1, pin #40. If there was power, but the fuel pump fuse was not energized, there may be an internal fault with the TIPM or a fuel pump relay failure – both would require a new TIPM.

The technician ran the diagnostic checks as advised and found no power at fuse M25. When he jumped B+ power to the fuse, the fuel pump ran, and the engine would start and run. Using a scan tool, he commanded the fuel pump ON. There was still no power at fuse M25, but power was present at TIPM connector C1, pin #40. At that point, he had narrowed down the problem to a fuel pump relay failure.

Confirmed Repair: The technician replaced the TIPM and cleared the DTCs. After the repairs, the Caravan started and ran normally. No DTCs returned after the test drive. Fixed!

Not an ALLDATA customer? For access to this valuable experience-based repair data and reliable OEM information, simply click here and start a free trial.

See more Tech Tips.