Chevy Truck Throws DTCs P0327 and P0332
Sep. 02 2023
Sep. 02 2023

Vehicle: 2001 Chevy K 1500, 4WD, V8-5.3L, VIN T, Automatic Transmission/Transaxle

Mileage: 225,889

Problem: The owner brought his truck in because the malfunction indicator light (MIL) was on. Engine performance seemed about normal.

Case Details: When the technician first connected the scan tool, he found DTC P0327 - Front Knock Sensor Circuit Low.

Using the scan tool, he found no response from the front knock sensor, so he removed the intake manifold to access both sensors. He found excessive corrosion on both knock sensors and the wiring harness.

The technician recommended replacing both knock sensors and the wiring harness with OEM parts.

Chevy K1500 Knock Sensors

After replacing both sensors, the wiring harness and reinstalling the intake manifold, he cleared the DTC and restarted the engine. The MIL came right back on. This time there were two DTCs:

  • P0327 - Front Knock Sensor Circuit Low
  • P0332 - Rear Knock Sensor Circuit Low

He thought there may be a problem with the harness, so the technician removed the intake manifold again. He tested the harness and the knock sensors. There were no issues with the harness and the resistance on both sensors was 103kohms, which was within specs. At this point, the technician called ALLDATA Tech-Assist for some guidance.

The Tech-Assist consultant suggested load testing the harness. It was okay. He also advised scope testing both sensors while tapping on the engine near the sensors with something metallic. There was no response from either knock sensor. The consultant then asked if the engine had a good ground. The technician checked and all ground points were good.

The only thing left was to order two more OEM sensors. The new sensors did not respond either. The technician tried a different scope and two more OEM sensors and got the same results.

This is where the story gets interesting. After going through a total of six OEM knock sensors, the technician decided to install a couple of aftermarket sensors. Both sensors responded perfectly during the scope test. The tech reinstalled the intake manifold, cleared the DTCs, started the engine and held his breath. The MIL did not come back on. A lengthy test drive verified the problem was finally fixed!

The ALLDATA Tech-Assist team fields cases like this every day. See how Tech-Assist can help your shop save time and money with on-call diagnostic support from ASE-certified Master Technicians. More Tech Tips 

Not an ALLDATA customer? For access to this valuable experience-based repair data and reliable OEM information, start a free trial today.

If you would like to read more articles like this one please subscribe to ALLDATA News.

Sign up for ALLDATA News